1

I am new to the RPi. I have a line in the interface file, iface eth0 inet static. Below that I have added, iface eth0 inet dhcp. Due to that, I'm unable to access my RPi. I have used my Pi ip as 192.168.2.80.

Jacobm001
  • 11,898
  • 7
  • 46
  • 56
shalini
  • 21
  • 1

1 Answers1

3

When you use ifconfig you can see the ipaddress that's currently used by eth0. You can access it through that ip.

Also, if you change the network config, don't forget to restart networking with sudo /etc/init.d/networking restart

I don't know if it CAN work with 2 settings, but I'd comment one out with putting # in front of each line. Also, if it's possible, post your network config. You might have made a mistake

Edit: There's a perfect tutorial here : How do I set up networking/WiFi/static IP address?

Community
  • 1
Lonefish
  • 215
  • 1
  • 12